Activating your Mobile Scanners

Follow

Here you will find out how to properly set up your mobile scanners!

 

Setting up the Genesis™ 7580g Mobile Scanner:

 

Step 1: Scan the keyboard barcode

The First barcode that needs to be scanned is right under the title "USB PC keyboard". Go ahead and scan that barcode and wait to hear the beep.

 

Step 2: Scan the modes barcode

Next, the second barcode that needs to be scanned will be on the page titled "Scan Modes". 

 

 

Success!

The red LED light will be present only when the screen of a high resolution device (such as cell phones or iPads) is placed before it.

                                              

 

 

 

Setting up the CR900FD Mobile Scanner:

 

 

 

Step 1: Scan the General Reading Settings QR Code

The First QR code that needs to be scanned is right under the title "Cell Phone Reading Enhancement On". Go ahead and scan that QR code and wait to hear the beep.

 

 

Step 2: Scan the Symbology Settings QR Code

Next, the second QR code that needs to be scanned will be on the page titled "PDF417 On". 

 

 

Success!

The blue LED light will be present only when the screen of a high resolution device (such as cell phones or iPads) is placed before it and you are pressing the trigger. You will hear a beep indicating that the scanner properly read the QR codes!

 

**Note** If using Internet Explorer, please make sure your cursor is on the find bar in your HUB before scanning. You will hear a beep for a good scan, and no beep if it did not take properly.

 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request
Powered by Zendesk